Publicité
Les langues disponibles
Les langues disponibles
B
Product usage
Pre-wash compartment
•
Washing product for pre-washing/soaking
Main wash compartment
•
Washing product for washing
•
Stain remover
•
Water softener (water hardness, category 4)
Fabric softener compartment
•
Fabric softener
•
Liquid starch Pour in the additives without exceeding the «MAX» mark.
Notes: Keep the washing products in a secure, dry place out of the reach of children.
•
Washing liquids can be used for wash cycles with a pre-wash. However, in
this case, a washing powder should be used for the main wash cycle.
•
Do not use washing liquids when activating the «Delayed start» function (if
this is available on your washing machine).
•
To avoid an uneven distribution of product when using highly concentrated washing liquid
or powder, use the washing net or ball supplied with the appliance, and place it directly
into the drum.
•
If you are using descaling agents, dyes or bleaches, make sure they are suitable for
household appliances. Descaling agents contain components that can damage the parts
of your washing machine.
•
Do not put solvents in your washing machine (e.g. benzene, turpentine).
•
If you are using starch powder, the procedure is as follows:
1.
Wash your laundry using the program you want.
2.
Prepare the starch-based solution, in accordance with the instructions provided by the
starch manufacturer.
3.
Select the «Rinse + Spin» program, reduce the speed to 1000 rpm and start the program.
4.
Pull the dispenser drawer towards you so that you can see approximately 3 cm of the
main wash compartment .
5.
Pour the starch-based solution into the main wash compartment while water is flowing
in the dispenser drawer.
6.
If you notice any starch residues in the dispenser drawer after the program has finished,
clean the main wash compartment.
Draining the waste water (depending on the model)
•
Before draining the waste water, switch off and unplug the appliance from the mains.
Remove the pump cover and place a container underneath.
1.
Pull the emergency drain hose from the machine.
2.
Place the end of the emergency drain hose in a container.
3.
Unscrew the emergency drain hose cap and remove it once it has been loosened.
4.
Wait until the water flows naturally.
23
EN
Publicité
