Publicité
Les langues disponibles
Les langues disponibles
B
Product usage
Connecting the water inlet hose
1.
If the water inlet hose is not already installed, it must be screwed into the washing machine.
The hose with the blue mark is for supplying cold water only.
2.
Screw the inlet hose onto the tap by hand and tighten the nut.
CAUTION:
•
Do not make a knot in the hose!
•
The washing machine must not be connected to the mixer tap of a non-
pressurised water heater.
•
Check that the connections are watertight by turning the water tap on fully.
•
If the hose is too short, replace it with a pressure- resistant hose of adequate
length (1000 kPa min, compliant with the EN 50084 standard).
•
Regularly check the inlet hose for any weakness or cracks, and replace it if
necessary.
•
The washing machine may be connected without a non-return valve.
Filling instructions
For models with two inlets
For models with a single inlet
•
Connect the inlet hose to the cold water tap and to the inlet valve at the rear of the
machine, as in Fig. 1.
•
Make sure that:
All the connectors have been properly tightened. Do not allow children to use, climb on and
stand next to your machine, or get inside the drum. Please note, that during wash cycles,
the surface temperature of the door may rise. When the appliance is operated with children
standing nearby, they must be kept under supervision at all times.
Water inlet
valve
10
Cool
Cold water
inlet
EN
Publicité
