Aosom 370-082 Instructions De Montage page 5

Battery Operating Specifications:
● Never mix new and old batteries, or different kinds of batteries.
● Never mistake positive and negative electrode of battery, or short circuit will happen.
● Non-rechargeable batteries are not to be recharged.
● Install batteries in a right polarity.
● Only adults can recharge or change batteries.
● Never make power port' s short circuit happen.
● Recharge the battery only when it is taken out of the toy car.
● Take exhausted battery out of the toy car and keep it out of Children's reach.
● Remove battery screws with a screwdriver, open battery cap as the arrow signals,
and in the 2.4G remote control model install two AAA 1.5V batteries in a right polarity.
● Assembly begins with the car body upside down. Be mindful of the shifter nob.
Support front and back of the car when assembling, elevating the car so shifter
nob is not at risk.
● Rotate the bumper support brackets into position and affix to bumper in aligning
holes.
● Align steering axle arm within the center steering bracket hole, inset steering
bracket into bracket mount on body and affix with screws.
● Unscrew and remove axle clamp from each suspension arm.
● Lift the rear axle frame allowing the suspension arm to align with the securing
points, re-attach the axle camps through the rear axle frame to each suspension
arm.
● Starting from one side, rotate the motor hub into alignment and insert the rear axle
through the motor hub and axle clamps and through the aligned motor hub on the
opposite side.
1.Front axle assembly
2. Rear axle assembly
5