Publicité
Les langues disponibles
Les langues disponibles
Gas Control Knob Setting
Electric gas ignition
The gas burner use an electric ignition device located near
each burner that by means a spark igniters ensure its surface
light automatically.
ELECTRIC IGNITION
Models with automatic re-ignition
The electronic auto re-ignition lights the surface burner
when the corresponding control knob is turned at any valve
rotation allowing sufficient gas flow to support a flame.
If any burner flame goes out for any reason, the igniter
automatically sparks to relight the flame.
NOTE: this feature is provided as a convenience
and is not intended as a safety feature.
To set:
• Push and turn a knob counter clockwise to any setting,
the corresponding spark plugs will generate a clicking
sound (spark), the burner will produce a flame and
reignite automatically if the flame goes out.
WARNING
• Do not operate a burner using empty cookware or
without cookware on the grate.
• Do not touch the burner when the igniters are clicking
(sparking).
• Do not let the burner flame extend beyond the edge of
the pan.
• Turn off all controls when not cooking.
Failure to follow these instruction can result in personal
injury or fire.
5 - Gas Cooktop Operation
Gas burners
The gas burners design of these cooktop models, allow
a pleasing option for cooking where size, power and
simmering are a primary concern.
Burners with two flame rings
This special burner has two separate flame rings to provide
a complete heat regulation from high power to simmering.
To set :
1. Push and turn the knob counter clockwise withing the
main HI - LO range, when the burner is turned on, the
main flame and the Simmer flame will both ignite and
remain on.
2. Set desired temperature within the main HI - LO range.
Note: The knob has a designed stop at MED heat setting.
To continue to low and / or simmer, push the knob
in as you continue to turn counter-clockwise. This
method is not required to go from LO / Simmer to
OFF.
Simmer setting
Continue turning the knob counter-clockwise to the 'HI-
LO SIMMER' range. The outer flame ring will go out and
temperature adjustment can be made using the inner flame
ring only.
Turning off the burner
Turn the knob clockwise as far as it will go to the off position.
Ensure flame extinguishes fully.
KNOB BURNER
EN
9
Publicité
