Star Progetti HELIOSA 9 Série Mode D'emploi page 16

Masquer les pouces Voir aussi pour HELIOSA 9 Série:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

adjust or clean the appliance and/or carry out user maintenance.
CAUTION
cause burns. Special caution must be taken if children or vulnerable
persons are near the appliance. Electrical repairs on these appliances
must be performed by qualified personnel, in order to comply with
current regulations. The appliance must not be installed directly under a
wall socket.If in doubt about installation, contact an authorized
technician.
In order to avoid overheating, do not cover the heater! If the power
cord is damaged, it must be replaced by the manufacturer or authorized
service agent or qualified personnel in order to avoid a hazard. In case
of doubt on installation, contact an authorized technician. The heater
must not be installed on a shelf.
Do not use the appliance where flammable vapours are present
(spirit, insecticides,petrol, etc.).
If you decide to stop using the appliance, switch it off and disconnect
it from the power supply, storing it out of reach ofchildren and differently
able persons. Also cut off the power cable to render the appliance
unusable.
Do not use the appliance in the immediate vicinity of bath tubs,
showers or swimming pools. Always respect the safety distances
prescribed by CEE-CEIstandards.
The appliance becomes very hot during use. Avoid all contact
between your skin and the hot surfaces of the appliance. Switch the
appliance off and wait at least 5 minutes for it to cool down before
performing any work on it
Do not make modificationsof any kind to this appliance.
Pay special attention when using it in rooms that are not manned.
Regularly inspect the appliance for visible defects. If any faults are
found, do not operate the appliance but contact Star Progetti
immediately.
Never position the appliance directly under a power socket.
The appliance must always be mounted horizontally
The appliance must be properly connected to an electrical system in
compliance with the applicable regulations and equipped with an
efficient earthing system. If in doubt, have a qualified electrician
perform a thorough check.
The appliance must be installed by a professional technician,
according to the instructions given in this booklet. Star Progetti cannot
assume any responsibility for damage to property or personal injury
resulting from failure to abide by the instructions given in this booklet
Use a multi-polar switch with minimum contact gaps of 3 mm when
installing the appliance.
Connect the appliance to the electrical
system is able to provide the maximum electrical voltage and capacity
indicated on the rating plate at maximum power.
Before carrying out any type of cleaning or
Some parts of this product may become very hot and
power supply only if the
16
maintenance

Publicité

Table des Matières
loading

Table des Matières