Product And Package Contents; Preliminary Warning Notices; Initial Operations, Safety Instructions - Laserworld Ecoline Série Mode D'emploi

1. Product and package contents

Please check if all listed parts are included and undamaged. Included in delivery:
1 x laser projector
1 x remote control unit

2. Preliminary warning notices

Please use this device only according to these operating instructions.
1.
Do not use the device if there are any visible damages on housing, connector
2.
panels, power supplies or power cords.
Never look directly into the light source of a laser projector. Danger of dama-
3.
ge to the eyes or even blindness in extreme circumstances!
Do not operate the device at high humidity, in the rain or in dusty
4.
environments.
Protect device against dripping or splashing water. Do not place
5.
any liquid filled containers near to this device.
Any warranty claims are void if the warranty label is removed or tampered

3. Initial operations, safety instructions

Make sure to use correct voltage;
1.
see information on device & in this
manual.
Make sure that the device is not
2.
connected to mains during ins-
tallation.
3. Installation has to be done by
technical experienced and qua-
lified persons according to safe-
ty regulations of the respective
country.
Always ensure that maximum
4.
permissible exposure (MPE) is
not exceeded in areas accessib-
le to the public or members of
staff.
5. In some countries an additional
inspection by technical control
institutes could be necessary.
1 x manual
1 x mini tripod
with in any way.
6. The power supply should be easily
accessible.
7. If the device has been exposed to
great temperature changes, do
not switch it on immediately. Con-
densation (or any moisture/water
formed) may damage device.
8. Never use dimmer, RC or other
electronically switched sockets.
Whenever possible, do not use the
laser projector together with large
appliances (especially fog machi-
nes) on the same mains!
Ensure sufficient ventilation and
9.
do not place the device on any
warm or heat radiating surface.
Especially the ventilation ope-
nings must not be covered!
10. Ensure that device does not get
1 x PSU