Working On The Device; Service Notes - Laserworld Ecoline Série Mode D'emploi

overheated. Make sure that the
device is not exposed to spotlights
(especially moving heads). Heat of
spotlights could overheat laser in
a little while and leads to a degra-
dation of performance.

4. Working on the device

1. Be sure that the mains plug is not connected to the power supply while
installing.
2. Take off all reflecting things like rings, watches etc. before starting to work
with or at the projector.
3. Only use non-reflecting tools to work on device.
4. Wear protective clothing (like goggles, gloves etc.) according to laser power
and wavelength of the laser.

5. Service notes

• Moisture and heat can reduce
lifetime of the laser system dra-
matically and expires any warranty
claim.
• Quick on/off switching of this de-
vice will reduce durability of the
laser diode dramatically.
• Avoid sharp knocks and shocks to
this device and ensure sufficient
protection during transportation.
Look after your Laserworld pro-
duct.
• To increase durability of your
laser, protect device against
overheating:
• Always ensure sufficient venti-
lation.
• Do not face spotlights (especially
moving heads) to the device.
• Check temperature after approx.
30 minutes with each new
installation. If necessary install the
projector at a place with different
temperature.
• Keep the device dry. Protect it
from moisture, rain and damp.
• Switch off device when it is not
needed. Diodes are switched on
and can wear out even if there is
no visible laser output.
• The devices of Ecoline Series are
not meant for professional appli-
cations. After approx. one hour of
operation, the device should cool
down for about 15 minutes.
• Please ensure the fans and hea-
tsinks are clear from dust and
debris otherwise the risk of over-
heating may occur. If the unit and
airways appear to be blocked then
please contact a qualified service
engineer to maintain and service
the product.
• Removal of the warranty label
as well as damages to the device
caused by improper handling,
neglect of the safety instruc-
tions and service notes will void
the warranty.