Pneumatic Connection - Festo 8129208 Notice D'utilisation

Single-Phase Energy Measurement Box – Operating Instructions

9.2 Pneumatic connection

1. Connect supply hosing (outside diameter 6 mm) in a depressurized state to the appropriate connection
"INx".
2. Connect load to the connection "OUTx".
3. Switch on compressed air supply (max. 10 bar).
The enclosed tees are designed to distribute one supply port to several measurement circuits.
The measurement circuits can also be integrated into 6 mm plastic tubing of an existing system using the
enclosed straight plug connectors. Appropriate adapters must be used for other tubing diameters.
1. Remove tubing (2) in a depressurized state from the system-side connection (1)
2. Plug straight plug connector (3) onto the tubing (2)
3. Integrate measurement circuit using 6 mm plastic tubing
System: System with connected energy measurement box:
29
© Festo Didactic 8130877