Pneumatic Design - Festo 8129208 Notice D'utilisation

Single-Phase Energy Measurement Box – Operating Instructions

8.3 Pneumatic design

The pneumatic measurement system has 3 independent measuring channels that each consist of a flow
sensor for measuring the air consumption and a pressure sensor for measuring the operating pressure.
The compressed air must always flow through the measurement system from connection "INx" to
connection "OUTx" so that the flow sensors can provide correct measurement values.
24
It is recommended to use a device for compressed air treatment, a pressure
regulator and a shut-off valve in the supply line.
Risk of injury from bursting parts!
The operating pressure must not exceed 10 bar rel.
WARNING
© Festo Didactic 8130877