Aqua Medic Premium Line Serie Mode D'emploi page 7

1. Product description
The reverse osmosis units of the Premium Line series for desalinating tap water with a capacity of
approx. 75 - 300 litres (depending on the type) per day consist of the following parts:
- Sediment prefilter, 10" with 5 µm pore size (6/10)
- Activated carbon filter (7/11)
- One or two reverse osmosis modules (depending on the type) with a first class synthetic
membrane (Polyamide/Polysulfon, TFC) which has a capacity of 75 - 90 / 120 - 150 / 240 – 300
litres (5) (two membranes with a capacity
- Flush valve: at this valve (3), the permeate/concentrate ratio is adjusted to 1:3 - 1:4 (3)
- Tap water connection fitting (3/4") with 3 m pressure tube
2. Set-Up
The system is delivered ready-to-use on a mounting unit. Fix it directly on the wall – preferably,
near a water tap.
Attention: Before first usage, please remove the protection foil from the membrane and
prefilters!
Now, you can connect the tubes. To avoid any failures, follow the instructions carefully:
Tube connections
The connections are as follows (Fig. 1):
1. Tap water inlet - into the sediment pre-filter (1)
2. Concentrate outlet (waste water) at flushing valve (3)
of 120 – 150 l/ day
1. Remove the blue lock ring.
2. Insert the hose to a complete stop into the fitting.
3. Refit the lock ring.
4. Pull the hose back as a test that it is located.
Removing the tubes:
1. Remove the blue lock ring.
2. Push the white ring at the fitting. Now, you can remove
the tube.
3. Please don't forget to refit the lock ring.
)
7