Publicité
Les langues disponibles
Les langues disponibles
Installation Instructions
7. The third row of brick is positioned in a manner
similar to the first row.
CAUTION: Be careful not to damage or
dislodge the element.
8. Repeat the pattern for the remaining rows.
9. Check that all the bricks are secure and evenly
located.
10. Close the core by replacing the inner panel
complete with insulation.
11. Ensure the bottom edge is located inside the
chassis and that the screws are tightly secured
at each edge.
!
NOTE: Double check all wiring connections
are secure and any excess cable is restrained
and cannot come in contact with any of the
heater casing. Under no circumstances should
any excess cable be pushed inside or behind the
heater.
CAUTION: Once installed do not attempt to
reposition the heater without first unloading the
bricks.
Figure 11
All manuals and user guides at all-guides.com
Reassembly
1. Replace all the panels of the outer casing
reverse steps 5-8 of Site Selection and
Preparation Section.
2. Ensure all of the hardware has been tightened.
3. Clean the outlet grille and adjacent surfaces
after the first operation as some dust may be
produced when the heater is first used.
In cases where unauthorized persons may tam-
per with the control settings it is possible to set a
tamper-proof feature at the time of installation, by
pressing and holding the Back button and the Se-
lector Dial simultaneously for three seconds, 'Child
Lock' will appear on the screen, repeat to reverse.
See the Operating Instructions for further details.
9
Publicité
