Publicité
Les langues disponibles
Les langues disponibles
Operation
the room temperature target is reached (the
temperature shown on the Display Screen).
!
NOTE: Advance is typically only required if the
heater is low on stored energy. Continue to press
Advance until Boost time desired is reached.
5. SELECTOR DIAL can be turned clockwise
and counter clockwise, and enables the
required room temperature to be adjusted.
The screen colour changes for warmer and
cooler settings, showing deep blue through
to bright red.
To check what setting the heater is currently
using press the selector dial once and the
timer mode will be displayed e.g. 'Work
Week'.
!
NOTE: The selector dial is also used in combi-
nation with the menu button to select and confirm
your settings.
Setting the Date and Time
Your Quantum controller incorporates a real time
clock with a calendar function. The time clock has
a battery back up that will keep the clock running in
the event of a power outage.
To adjust the time or date follow the steps below.
!
NOTE: The display screen will return to stan-
dard display after a period of 20 seconds of inactiv-
ity.
•
Press the Menu Button (1).
•
Select Date/ Time by pressing the control
dial (2).
•
Rotate the dial to select the correct 'day' and
All manuals and user guides at all-guides.com
press the centre of the dial to select.
•
Rotate the dial to select the correct 'Day of
the Month' and press the centre of the dial
to select. Repeat this operation until date
and time have been sent and the display
returns to the Main Menu.
!
NOTE: When the heater is initially installed, a
Warning Message may appear. This means the
real time clock has not been initialized. This can be
set by pressing the Menu button and following the
above steps to set the time.
Choosing and Setting a Timer Mode
Your Quantum controller comes pre-programmed
with a set of operating periods.
There are four options available - Three preset,
and one user setup;
!
NOTE: The Work Week, Home all Day and
Manual timer modes will use the comfort tempera-
ture during the "On" times and a setback tempera-
ture during the "Off" times. How to set the setback
temperature can be found under the description of
the "Options" Menu in this document.
1. Work Week (pre-programmed) - Has the fol-
lowing preset times, which can be altered if
desired;
Monday – Friday: On 6:00 am until 8:00 am
Monday – Friday: On 4:00 pm until 10:00 pm
Saturday – Sunday: On 6:00 am until 10:00 pm
2. Home all Day (pre-programmed) - – Has the
following preset times Monday to Sunday,
which can be altered if desired;
6:00 am until 10:00 pm
11
Publicité
