Publicité
Les langues disponibles
Les langues disponibles
Installation Instructions
WARNING: This appliance is heavy. The floor
must be checked to ensure that it is capable of
bearing the weight of the unit up to 177 kg (390
lbs).
WARNING: Do not under any circumstances
attempt to move or reposition this heater
without seeking expert advice.
CAUTION: The heater must be securely fixed
to a wall before operation.
CAUTION: Do not install the unit on carpet or
any other soft surface. If installing in a carpeted
area remove the carpet and underlay so that the
feet rest directly on the floor. Ensure that the unit
is level.
1. Place the heater in its final position and mark
the fixing holes through the location holes
visible through the back of the heater.
Mark the fixing positions at the two extreme
ends of the heater with the heater pushed tight
against the wall.
Remove the wall bracket from the heater by
removing the two screws at each end of the
bracket. Place the heater to one side and
position the bracket against the wall aligning it
with the location marks.
2. Six screw locations, on the bracket, must be
selected for each model. Mark the positions for
the screw holes. Remove the bracket from the
wall, drill the holes and mount the bracket using
the appropriate hardware for that particular type
of wall.
3. Secure the heater to the bracket using the
screws previously removed.
CAUTION: Under no circumstances should
these screws be removed without first removing all
bricks from the heater.
Electrical Connections
WARNING: The installation of this appliance
should be carried out by a competent
electrician and be in accordance with National
Electrical Codes (NEC) and local codes.
1. The heater is factory configured to operate with
one main power supply.
2. Storage/Fan Circuit:
• Ensure the black wire is connected to the
All manuals and user guides at all-guides.com
Figure 7
Figure 8
Mounting Holes
7
Publicité
