Connections; Connecting The Power Cord; Connecting Peripheral Devices - Sony UPA-PC105 Mode D'emploi

Connections

Connecting the Power Cord

Connect the supplied power cord to the AC power
connector on the back of the unit, and then connect the
plug to a power outlet.
Power cord
(supplied)

Connecting Peripheral Devices

The peripheral devices shown below can be connected to
the unit.
Note
To prevent causing a fire or damage to the system, never
attempt to connect any peripheral device other than
those specified.
SCSI
USB
USB devices
SCSI Devices
The devices listed below can be connected to the SCSI
connector. For details about connection, refer
"Connecting a Peripheral Device to the SCSI Interface".
• UP-DR100 (printer)
* Up to three units can be connected.
• UP-D70A (8 × 10 size compatible printer)
• UY-S90/S100 Film Scanner
Connecting USB Devices
Connect the unit's USB connector to a flatbed scanner.
For details about how to connect a USB device, see
"Connecting a Peripheral Device to the USB Interface".
It is also possible to connect a receipt printer, card
reader, etc. Consult your retailer for details about the
types of peripherals compatible with the unit.
Connecting a Peripheral Device to the
SCSI Interface
This section describes how to connect a peripheral
device to the SCSI connector.
For details about the SCSI ID and terminator, refer to the
instructions that you received with the device.
Notes
Power outlet
• Before connecting the device to the unit, make sure
that the device and the unit are switched off.
• Connect the power cord last.
1
Follow the procedure below to connect a peripheral
device equipped with an SCSI interface to the unit.
SCSI
devices
To the SCSI
connector
SCSI cable (supplied)
SCSI device
9
GB
Connections