Energetics TZ-2175 Manuel page 4

The display and it's symbols
SP / Speed (km/h)
TIME / Time (min; sec)
DIST / Distance (km)
SET – to confirm the
selection or value &
increase the parameters
MODE – scans through
display functions
Button Functions
MODE
1. Press the button to select TIME, DISTANCE and CAL to preset, and enter after setting.
2. Press the button to scan through the values in the display (Time – Calories – Odometer – Pulse – Speed – Distance).
3. Press the button and hold for 2 seconds to reset all values to zero (except odometer).
SET
To adjust the target value of TIME, DISTANCE and CAL.
Press the button and hold for 2 seconds to speed up the increasing.
RESET
Press the button to reset the value.
Press the button and hold for 2 seconds to reset all values to zero (except odometer).
Functions & Operations
Batteries Installation
Insert 2 pieces of AA 1.5 V batteries in the battery case on the back of monitor.
Whenever batteries are removed or replaced, all values will be reset to zero except for the odometer.
Auto On / Off
While the user starts to do exercise, the display will show the workout value automatically. If the computer does not
receive a signal for more than 4 minutes the display will turn off automatically. All values are reset to zero except for
the odometer which will accumulate the total distance continuously.
4
www.energetics.eu
All manuals and user guides at all-guides.com
ODO / Odometer
accumulates total
distance (km)
PULSE / Pulse
(beats per minute)
CAL / Calories burned
RESET – to set all values
back to zero (hold button)