RIDGID R4112 Manuel D'utilisation page 10

FEATURES
KNOW YOUR COMPOUND MITER SAW
See Figure 1.
The safe use of this product requires an understanding of
the information on the tool and in this operator's manual as
well as a knowledge of the project you are attempting. Before
use of this product, familiarize yourself with all operating
features and safety rules.
10 in. BLADE
A 10 in. blade is included with your compound miter saw. It
will cut materials up to 5-1/2 in. wide, depending upon the
angle at which the cut is being made.
15 AMP MOTOR
This saw has a powerful 15 amp motor with sufficient power
to handle tough cutting jobs. It is made with all ball bearings,
and has externally accessible brushes for ease of servicing.
BEVEL LOCK KNOB
The bevel lock knob securely locks your compound miter
saw at desired bevel angles. Loosen the bevel lock knob to
release the saw allowing the blade to be tilted either left or
right for bevel cuts. Tighten the knob to lock the saw in place.
NOTE: To obtain right bevel angles, pull the bevel stop pin
out and tilt the saw to the desired angle. Push the bevel stop
pin in for a positive 0° bevel stop.
BEVEL STOP ADJUSTMENT SCREWS
See Figure 2.
Bevel stop adjustment screws have been provided on each
side of the saw arm. These adjustment screws are for mak-
ing fine adjustments at 0°, 33.9°, 45° and 48°.
NOTE: Use the bevel stop turrets to locate 33.9°, 45°, and
48° bevel angles. When making any non-bevel cut, the bevel
stop turrets should be in the 48° position.
CARRYING HANDLE
See Figure 3.
For convenience when carrying or transporting the miter
saw from one place to another, a carrying handle has been
provided. To transport, turn off and unplug the saw, then
lower the saw arm and lock it in the down position. Lock
saw arm by depressing the lock pin.
ELECTRIC BRAKE
An electric brake has been provided to quickly stop blade
rotation after the switch is released.
LASER GUIDE
For more accurate cuts, a laser guide is included with your
miter saw. When used properly, the laser guide makes
accurate, precision cutting simple and easy.
LASER GUIDE SWITCH
See Figure 3.
Use the laser guide switch to turn the laser guide on and off.
All manuals and user guides at all-guides.com
BEVEL STOP ADJUSTMENT
SCREW FOR 45 ° ANGLES
MITER LOCK
10
LASER GUIDE
SWITCH
LEVER
SAW ARM LOCKED IN DOWN POSITION
33.9º
45º
48º
BEVEL STOP
TURRET
Fig. 2
LOCK
PIN
CARRYING
HANDLE
Fig. 3