Installation - ZANKER KEV6340FBB Notice D'utilisation

Problem
The appliance deactivates.
The residual heat indicator does not
come on.
The sensor fields become hot.
comes on.
comes on.
and a number come on.
If you tried the above solutions and cannot repair the
problem, speak to your dealer or the customer service.
Give the data from the rating plate, three digit letter
code for the glass ceramic (it is in the corner of the
glass surface) and an error message that comes on.

Installation

Warning! Refer to the Safety chapters.
Before the installation
Before the installation of the appliance, record the infor-
mation below from the rating plate. The rating plate is on
the bottom of the appliance casing.
• Model ...........................
• PNC .............................
• Serial number ....................
18
Possible cause
You put something on the sensor
field .
The cooking zone is not hot be-
cause it operated only for a short
time.
The cookware is too large or you
put it too near to the controls.
The Automatic Switch Off operates.
The Child Safety Device function
operates.
There is an error in the appliance.
Make sure, you operated the appliance correctly. If not
the servicing by a customer service technician or dealer
will not be free of charge, also during the warranty peri-
od. The instructions about the customer service and
conditions of guarantee are in the guarantee booklet.
Built-in appliances
• Only use the built-in appliances after you assemble
Connection cable
• The appliance is supplied with the connection cable.
• Replace the damaged mains cable with a special ca-
Remove the object from the sensor
field.
If the cooking zone operated suffi-
ciently long to be hot, speak to the
service centre.
Put large cookware on the rear
cooking zones if necessary.
Deactivate the appliance and acti-
vate it again.
Refer to the chapter "Daily Use".
Disconnect the appliance from the
electrical supply for some time. Dis-
connect the fuse from the electrical
system of the house. Connect it
again. If
to the service centre.
the appliance into correct built-in units and work sur-
faces that align to the standards.
ble (type H05BB-F Tmax 90°C; or higher). Speak to
your local Service Centre.
Remedy
comes on again, speak