Installation - ZANKER KEE6040X Notice D'utilisation

Problem
If you tried the above solutions and cannot repair the
problem, speak to your dealer or the customer service.
Give the data from the rating plate, three digit letter
code for the glass ceramic (it is in the corner of the
glass surface) and an error message that comes on.

Installation

Warning! Refer to the Safety chapters.
Before the installation, note down the serial
number (Ser. Nr.) from the rating plate.The rating
plate of the appliance is on its lower casing.
KEE6040X
220-240 V 50-60-Hz
MEE 00 05
ZANKER
Built-in appliances
• Only use the built-in appliances after you assemble
the appliance into correct built-in units and work sur-
faces that align to the standards.
Possible cause
Problem with the house electrical
system.
Make sure, you operated the appliance correctly. If not
the servicing by a customer service technician or dealer
will not be free of charge, also during the warranty peri-
od. The instructions about the customer service and
conditions of guarantee are in the guarantee booklet.
Connection cable
• Use the correct mains cable of type H05BB-F Tmax
• Replace the damaged mains cable with a special ca-
949 594 306 00
7 kW
Examine the fuse in the electrical
system of the house in the fuse
box. If the fuses blow again and
again, speak to qualified electrician.
90°C (or higher) for a single phase or two phase
connection.
ble (type H05BB-F Tmax 90°C or higher). Speak to
your local Service Centre.
Remedy
13