Kärcher K 3.700 Mode D'emploi page 17

Description of the Appliance
These operating instructions describe
–
the basic models of the high pressure
cleaners shown on the front cover.
These operating instructions describe
–
the maximum equipment. Depending
on the model, there are differences in
the scopes of delivery (see packaging).
Illustrations on fold-out page!
1 Coupling element for water
connection
2 Water connection with integrated sieve
3 Appliance switch "0/OFF"/ „I/ON"
4 High pressure hose
5 Dosage regulator for detergent
6 Storage for trigger gun
7 High-pressure hose drum
8 Transport handle
9 Hand crank for hose drum
10 Storage of Plug 'n' Clean detergent bot-
tle with detergent connection
11 Storage for accessories
12 Storage hook for mains connection cable
13 Mains cable with mains plug
14 Plug 'n' Clean detergent bottle with
locking lid
15 Wheels
16 Trigger gun
17 Lock trigger gun
18 Key to detach the high pressure hose
from the trigger gun
19 Spray lance with pressure regulation
(Vario Power)
20 Spray lance with Dirtblaster
21 Washing brush
22 Rotary washing brush
23 Delta-Racer D150
All manuals and user guides at all-guides.com
Mount loose parts delivered with appliance
prior to start-up.
Install wheels
Illustration
 Push the wheels into the intake and se-
Install the storage for hand-spray gun
Illustration
 Place the bottom holder into the recess-
 Insert the top holder and push down all
Install the storage hook for the mains
connection cable
Illustration
 Press in the storage hook and lock it
Install the transport handle
Illustration
You will need the 2 included screws as well
as a Philips screwdriver PH 2.
 Slide the transport handle into the guide
Install the dosage regulator for
detergent
Illustration
You will need the 2 included screws as well
as a Philips screwdriver PH 2.
 Insert both detergent hoses onto the
 Install the dosage regulator and con-
Note: During installation you must make
sure that the tongues of the dosage regula-
tor match up with the intended recesses in
the casing.
Install the high pressure hose drum
Illustration
 Slide the free end of the coiled high
 Insert the hose drum into the intakes on
 Insert the axle of the hand crank into the
– 8
EN
Before Startup
cure them with the plugs. Align the plug
properly.
es and push forward until it audibly
locks in.
the way.
into the top position.
and secure it with 2 screws.
hose fittings.
nect using 2 screws.
pressure hose through the recesses on
the dosage regulator.
the transport handle.
guides.
17