Assembly And Adjustment Before Use; Starting, Operating And Stopping The Engine - KLIPPO 1:08 Manuel D'utilisation

If you run over anything or if the lawnmower vibrates
abnormally, stop the lawnmower immediately and wait
until all moving parts have stopped. Then investigate
the cause, be careful as above, and deal with the fault
before continuing to mow the grass.
Never lift or tilt the machine when the engine is
running. Ensure that the power cable is disconnected
and that the blade has stopped before lifting or tilting
the machine.
Slopes should be mowed with great care. Never
pull the lawnmower upwards and downward when
mowing slopes. Be particularly careful when turning on
slopes.
Take care to stop the lawnmower if people or
animals move into the cutting area.
Be careful when you approach hidden corners and
objects that may obscure your view.
Be aware of hollows, roots or bumps. High grass
can hide obstacles.
The handle
Fit the handle to the handle link and tighten the handle
link. Make sure the cables do not get caught! If the
height of the handle is not comfortable, try moving the
handle screws (position D) to the top position. Use the
attached cable tie to fasten the cable to the handle.
Adjusting the cutting height
The cutting height can be easily adjusted using a single
lever located by the left back wheel (position E). Move
the lever forward for a higher grass height. The positions
of the lever correspond to a cutting height of 25-50 mm.

STARTING, OPERATING AND STOPPING THE ENGINE

1. Place the lawnmower on a part of the lawn with
little grass and with the height setting control (position
E) in the top position.
2. First press and hold the start button (position B).
3. Then pull the safety grip towards you.
4. Hold the start button in and release once the
lawnmower starts. The lawnmower will then run as long
as the safety grip is held in.
5. If you want to stop the lawnmower, release the
safety grip.
SAFETY REGULATIONS

ASSEMBLY AND ADJUSTMENT BEFORE USE

Be particularly careful when reversing the machine
or pulling it towards you.
Turn off the lawnmower when crossing areas con-
taining gravel.
Always unplug the lawnmower when leaving the
machine unattended and wait until all moving parts have
stopped.
Maintenance and storage
Only use original spare parts.
The cutting blade is sharp and may cut you. Use
protective gloves when working on the blade.
Be aware of the danger of crushing injuries when
adjusting the lawnmower.
Check that all the safety controls are secured and
function correctly.
Never use the machine in the rain and always store
it in a dry location. Disconnect the power cable when
storing it so that the machine cannot start accidentally.
Before starting the engine
Inspect the lawnmower and check that the blades are
in good condition, the blade bolt and other screws are
tightened and that the lawnmower is free of damage.
Never use a defective lawnmower!
Ensure that the cable is free of damage and inten-
ded for outdoor use. First connect it to the lawnmower
and attach it to the cable grip that hangs from the
handle and then to an earthed socket with a 10A inert
fuse connected to an earth switch.
The lawnmower is equipped with an overload fuse to
protect the engine. If this trips out, wait a few minutes
until it starts again. Remove the reason for the overload
(too much grass, twigs, etc.) before starting the lawn-
mower again.
Never leave the lawnmower without removing the
power cable so that children or other persons cannot
accidentally start the machine.
22