Options; Operating Controls - Maytag BRAVOS MTW6600TB0 Guide D'utilisation Et D'entretien

7. Press START. The countdown in hours to the wash cycle will show in the time display
window and the indicator light will begin to flash.
NOTE: The Start indicator light will not flash when Delay Wash is chosen. You must press
Start to initiate a countdown for the cycle to begin.
To change the Delay Wash time:
Press PAUSE/CANCEL.
Press DELAY WASH to select the desired delay time.
Press START to begin the countdown.
To cancel Delay Wash:
Press START again to begin the cycle right away or press PAUSE/CANCEL twice.
Use these pads to select the desired options for your wash cycle.
Stain Cycle
This option provides enhanced cleaning action for tough stains. The Super Wash cycle
automatically includes Stain Cycle. Choosing Stain Cycle will add approximately 5 minutes
to a cycle. Stain Cycle should be started on a dry load only and cannot be selected after the
tub has started filling with water.
Stain Cycle may be selected as an option with other cycles. See table for details.
Cycle
Whites
Super Wash
Bulky
Sheets
Normal
Wrinkle Control
Colors/Jeans
Quick Wash

Options

Stain Cycle
(Adds time to the wash cycle)
Option
Default
Not available
Not available
Option
Option
Option
Option
Cycle
Delicate
Handwash
Clean Washer with bleach only
Soak
Rinse & Spin
Spin Only
Extra Rinse
An extra rinse can be used to aid in the removal of detergent or bleach residue from garments.
This option provides an additional rinse with the same water temperature as the first rinse.
This is the default rinse setting for the Whites cycle.
Pre Soak
Use this option for set-in stains and soil that need extra time for removal. Soaking in this
washer is different than in a conventional washer. The washer sprays the load with water and
detergent at extra-low spin speed followed by a brief period of wash action at the speed of the
selected cycle. This action is repeated. Pre Soak cycles through a series of sprays and wash
actions followed by a pause to allow the detergent to work on the soils. The Pre Soak feature
is followed by the selected cycle. Using Pre Soak will extend your wash cycle.
End of Cycle Signal Volume
The End of Cycle Signal produces an audible sound when the wash cycle is finished. This
signal is helpful when you are removing items from the washer as soon as it stops. Select
High, Low or Off.

Operating Controls

Power
Press POWER to turn the washer on or off.
Stain Cycle
(Adds time to the wash cycle)
Option
Option
Not available
Not available
Not available
Not available
19