Status Lights; Stopping The Washer; Changing Cycles, Modifiers, And Options; Indicator Lights - Maytag BRAVOS Guide D'utilisation Et D'entretien

To restart the washer
1. Close the lid and press START/PAUSE.
2. To unlock the lid after the Add a Garment period, press START/PAUSE once. Pressing
POWER/CANCEL will cancel the wash cycle.

Stopping the Washer

You can stop the wash cycle and drain the tub by pressing the Power/Cancel button once.

Changing Cycles, Modifiers, and Options

You can change Cycles, Modifiers, and Options anytime before Start/Pause is pressed. Not all
Modifiers and Options are available for all cycles.
A short tone sounds when a change is selected. If you press and hold the End Signal option
■
for more than five seconds, all valid beeps will be eliminated. To turn the signals back on,
press and hold the End Signal button for five seconds.
Three short tones sound if an unavailable combination is selected. The last selection will
■
not be accepted.
To return all options and modifiers to Factory Default, press POWER/CANCEL, select
■
Drain & Spin cycle, and then press Extra Rinse, Fabric Softener, Extra Rinse, or Fabric
Softener within 5 seconds. When done correctly, the 7-segment displays show "Fd" for
3 seconds and then unit returns to Standby Mode.
Changing Cycles after pressing Start
1. Press POWER/CANCEL once to cancel the cycle. The washer will drain.
2. Select the desired wash cycle.
3. Select the desired Modifiers and Options.
4. Press START/PAUSE.
The washer restarts at the beginning of the new cycle.
NOTE: If you do not press Start/Pause within 5 minutes of pausing the washer, the washer
automatically shuts off.
Changing Modifiers and Options after pressing Start/Pause
You can change a Modifier or Option anytime before the selected Modifier or Option begins
by choosing the desired Modifiers and/or Options.
NOTE: An error tone will sound if your selection is unavailable.
To manually drain the washer and spin the load
1. Press POWER/CANCEL once to cancel the wash cycle and drain the washer.
2. Turn knob to select DRAIN & SPIN.
3. Press START/PAUSE.
When the spin is complete, the lid unlocks. Items can be removed from the washer.

Status Lights

These lights show which portion of the cycle is operating. They also indicate when you can
add other garments to the wash load.

Indicator lights

An indicator light shows which Cycle, Modifiers, and Options you have selected.
Estimated Time Remaining
When a wash cycle is started, the estimated time remaining for the cycle, including fills and
drains, will be displayed. The time will count down to the end of the cycle.
Turn the knob to choose the correct wash cycle for the type of fabrics you are washing. When
the knob points to a cycle, the cycle and Start/Pause indicator lights will blink. If the default
settings for the Modifiers and Options are acceptable, you may press Start/Pause to begin the
wash cycle.
Preset Cycle Settings
For ease of use, preset cycle settings provide the recommended fabric care settings
for each cycle.
Cycles
15