Publicité
Les langues disponibles
Les langues disponibles
Loosen the fastening of the side protection and tilt it as
5
shown in the following image
Carefully pull the barrel out and remove it complete-
7
ly
Separate the lower protector from the machine.
9
To do this, hold the protector by the output
opening, rotate it upwards and then pull on it.
Tilt the bracket to access the bottom of the blade.
11
20
Remove the drive belt partially and rotate the barrel
6
to fully disengage it.
Remove the lower protector, unlocking the latches and
8
simply pulling it to disengage the retaining clips.
Loosen and remove the nut on the adjustment
10
mechanism with a xed spanner No. 16. Also remove
the spring and the washer. Repeat the process on the
other end.
The motors are waterproof due to their IP66 and IP67
12
protections. Clean all the parts with a high-pressure
cleaner (except for the barrel on which you must not
apply any pressure) paying particular care to the
upper and lower part of the blade, since more residue
usually accumulates on it and on the reel assembly.
Placing the bottom protector on the machine will
help channel the water while cleaning is in progress.
Finally, sterilize and disinfect all parts of the machine
with our Master Clean product.
Check the video to see how to clean the MT
Tumbler 500 using this QR code or look for the
video on our YouTube channel "Cleaning the
blade of the MT Tumbler 500".
Publicité
