Publicité
Les langues disponibles
Les langues disponibles
View the video of the MT Tumbler 500 in operation using this QR code or, look
for the video on our YouTube channel "Industrial medical cannabis trimmer
MT Tumbler 500".
To work with two units of the MT Tumbler 500 it's necessary to use the MT Tumbler 500 Rail and adjust the inclination of the
tandem according to the conditions of the product and the variety to process.
View the video of the MT Tumbler 500 Full System in operation using this QR
code or search for the video on our YouTube channel "Medical Cannabis
Trimmer MT Tumbler 500".
Quality control
Check the appearance of the owers when leaving the barrel. If the owers are not clean enough, this is usually because:
+The aspiration is too slow (the leaf collector is dirty/blocked).
+
The cutting blade is not properly adjusted.
+
The machine is dirty. It will need maintenance.
+
The spacing between the blade and the barrel is not correct.
+
The owers have not been in the barrel for long enough. You are probably adding owers too quickly. The machine works
best when the barrel is half-full.
Maintenance
For a good nal result it is essential to perform periodic maintenance on the machine. The following steps for cleaning and adjus-
ting the blades are described below. If you work 100% with the machine it will be necessary to clean it every 4-5 hours of work to
have a good cut and performance.
Cleaning
To clean the support and the blade, you will need an 16-millimetre open spanner and a pressure washer.
Turn o
the leaf collector and MT Tumbler 500 by
1
X
pressing the OFF buttons and disconnect both from the
power supply (G).
Remove the top protection. Pull the protection
3
inward slightly, open it 45 , and slide it through its
fastenings.
Separar el aspirador de la máquina extrayendo el tubo
2
de la boca de entrada de la máquina peladora.
Remove the hopper (B) by loosening the
4
fasteners (E).
19
Publicité
