Publicité
Les langues disponibles
Les langues disponibles
Do not open, crush, overheat or set fire to
the battery. Non-observance of this warning
may result in burns and fire. Follow the
manufacturer's instructions.
Extinguish burning Li-ion batteries with
water, sand or a fire blanket.
Avoid physical blows/impact. Impact and
penetration of objects can damage batter-
ies. This may result in leakage, heat build-up,
smoke generation, ignition or explosion of
the battery.
Never charge the battery unattended over-
night. Fire and explosion hazards can result
in case of non-observance.
Do not remove the battery from its original
packaging until it is going to be used.
Handling hazardous dusts.
When working with power
WARNING
tools, such as when grind-
ing, sanding, polishing, sawing or for other
work procedures where material is
removed, dusts develop that are both haz-
ardous to one's health and can spontane-
ously combust or be explosive.
Contact with or inhaling some dust types
can trigger allergic reactions to the operator
or bystanders and/or lead to respiratory
infections, cancer, birth defects or other
reproductive harm.
Examples of such materials which contain
chemicals that can produce hazardous dusts,
are:
– Asbestos and materials containing asbes-
tos;
– Lead-containing coatings, some wood
types such as beech and oak;
– Minerals and metal;
– Silicate particles from bricks, concrete
and other materials containing stone;
– Solvent from solvent-containing paint/
varnish;
– Arsenic, chromium and other wood pre-
servatives;
– Materials for pesticide treatment on boat
and ship hulls;
– Stainless steel dust, metal dust and non-
ferrous metal dust;
Remove the battery only when the power
tool is switched off.
Before any work on the machine itself,
remove the battery from the power tool. If
the power tool accidentally starts, there is
danger of injury.
Protect the battery against moisture and
water. Clean contaminated battery terminals
and power tool connections with a dry,
clean cloth.
Remove the battery when transporting and
storing the power tool.
Observe the safety instructions in the manu-
als of the chargers from FEIN or the AMP-
Share partners.
To minimize the unwanted intake of these
materials:
– Use dust extraction matched appropri-
ately for the developing dust.
– Use personal protective equipment, such
as a P2 filter-class dust protection mask.
– Provide for good ventilation of the work-
place.
The risk from inhaling dusts depends on
how often these materials are worked.
Materials containing asbestos may only be
worked on by specialists.
Wood and light-metal dust
CAUTION
can cause spontaneous com-
bustion or explosions.
Hot mixtures of sanding dust and paint/var-
nish remainders or other chemical materials
in the filter bag or the vac filter can self-ignite
under unfavorable conditions, such as spark-
ing from sanding metal, continuous sunlight
or high ambient temperatures. To prevent
this:
– Avoid overheating the material being
sanded and the power tool.
– Empty the dust collector/container in
time.
– Observe the material manufacturer's
working instructions.
– Observe the relevant regulations in your
country for the materials being worked.
en
7
Publicité
