Publicité
Les langues disponibles
Les langues disponibles
Changing the tool.
Before mounting or replacing application tools or accessories, remove the
WARNING
battery. This preventive safety measure rules out the danger of injuries
through accidental starting of the power tool.
For all work or when changing application tools, always wear protective
CAUTION
gloves. Danger of injury from the sharp edges of the application tools. Appli-
cation tools can become very hot while working. Danger of burns!
Do not switch the power tool
CAUTION
on while the clamping lever
is open. Otherwise there is danger of
crushes or contusions to the hand and fin-
gers.
Do not actuate the clamping
CAUTION
lever while the power tool is
running. Otherwise there is danger of injury.
Do not reach into the area of
CAUTION
the clamping jaws. Other-
wise there is danger of crushes or contu-
sions to the fingers.
Inserting the application tool
(figure 7).
Clean the tool holder and the application
tool.
In the starting position, the clamping jaws in
the tool holder are together. In this position,
the application tool can be clipped-in easily.
Do not operate the power
CAUTION
tool with open clamping jaws
and without an application tool! This could
damage the power tool.
When the clamping jaws are
CAUTION
open before the application
tool is inserted, pivot the clamping lever
toward the front and then back again. The
clamping jaws are closed now. The applica-
tion tool can be inserted.
Fig. 7
1.
3.
en
2.
19
Publicité
