Publicité
Les langues disponibles
Les langues disponibles
Working instructions.
Before mounting or replacing application tools or accessories, remove the
WARNING
battery. This preventive safety measure rules out the danger of injuries
through accidental starting of the power tool.
Do not use accessories not specifically intended and recommended for this power tool by
FEIN. The use of non-original FEIN accessories can lead to overheating of the power tool
and destroy it.
For each job, use only the FEIN application tool released and intended for
CAUTION
the respective application.
Switching on and off (figure 10).
Always hold the power tool
CAUTION
firmly. Otherwise, you could
lose control over the power tool.
The self-start prevention lock prevents the
power tool from automatically starting
when the battery is inserted while the on/off
switch is set to on.
If the power tool shuts off without the
switch being actuated, switch the power
tool switch off, remove the battery and reat-
tach it.
Guide the power tool toward the work
piece only when switched on.
Switching on:
Push the switch toward the front (I).
Switching off:
Push the switch toward the rear ().
Setting the oscillating frequency
(figure 11).
Adjust the oscillating frequency infinitely
variable with the dial control.
Turn the dial control between "1" for the
lowest speed and "6" for the highest speed.
Fig. 10
Fig. 11
Thumbwheel for pre-selection
6
5
4
en
On/Off switch
3
2
1
21
Publicité
