Supplied Components; Preparing The Remote Control Unit - Sharp PN-R606 Manuel D'installation

If any component should be missing, please contact your dealer.
 Liquid Crystal Display Monitor: 1
 Remote control unit: 1
 Power cord: 1
 R-03 battery ("AAA" size): 2
 CD-ROM (Utility Disk for Windows): 1
 Setup Manual (this manual): 1
 Cable clamp: 2
 Logo sticker: 1
 Hole cover sticker (PN-R706 only): 2
[PN-R706/PN-R606]
 Ceiling mounting bracket: 8
 Ceiling mounting bracket fixing screw: 24
[PN-R556/PN-R496/PN-R426]
 Ceiling mounting bracket: 4
 Ceiling mounting bracket fixing screw: 12
* SHARP Corporation holds authorship rights to the Utility Disk program. Do not reproduce it without permission.
* For environmental protection!
Do not dispose of batteries in household waste. Follow the disposal instructions for your area.

Preparing the Remote Control Unit

1. Place your finger on the part marked with the ▲, and then pull the cover off.
2. See the instructions in the compartment and put in the supplied batteries (R-03 ("AAA" size) x 2) with their plus (+)
and minus (-) sides oriented correctly.
3. Close the cover.

Supplied Components

5
E