Publicité
Les langues disponibles
Les langues disponibles
7. Canopy Assembly.
Locate 2 screws on underside of hanging
bracket and remove screw closest to the
open end of the hanging bracket.
Partially loosen the other screw. Lift
canopy to hanging bracket. Place
rounded part of slotted hole in canopy
over loosened screw in hanging bracket
and push up. Twist canopy to lock.
Re-insert screw that was removed and
then tighten both screws securely.
8. Blade Assembly.
WARNING: To reduce the risk of serious
bodily injury,
DO NOT use power tools
to assemble the blades. If screws are
overtightened, blades may crack and
break.
Locate 6 blade screws/lock washers in
hardware pack. Align blade holes with
motor screw holes and attach blade
with screws/lock washers. Repeat this
procedure with remaining blades.
Secure all screws/lock washers with a
Phillips screwdriver.
NOTE: Tighten blade screws twice a year.
screw
canopy
blade screw/
lock washer
page 8
hanging
bracket
screw
motor
housing
blade
Publicité
