Publicité
Les langues disponibles
Les langues disponibles
5. Fan Assembly. (cont.)
Remove electrical tape from electrical wiring
and thread each of the wires through a
different hole in the weatherproof hanging
ball cover. Pull weatherproof hanging ball
cover down securely over hanging ball (on
downrod). [Refer to diagram 5.]
WARNING: Failure to tighten set screw on
hanging ball completely could result in the fan
becoming loose and possibly falling.
With the hanging bracket secured to the
outlet box and able to support the fan, you are
now ready to hang your fan. Grab the fan
firmly with two hands. Slide downrod through
opening in hanging bracket and let hanging
ball rest on the hanging bracket. Turn the
hanging ball slot until it lines up with the
hanging bracket tab. [Refer to diagram 6.]
WARNING: Failure to align slot in hanging ball
with tab in hanging bracket may result in
serious injury or death.
Tip: Seek the help of another person to hold
the stepladder in place and to lift the fan up to
you once you are set on the ladder.
Find a secure attachment point (wood ceiling
joist highly recommended) and secure safety
cable. It will be necessary to use a heavy duty
wood screw, washer and lock washer (not
supplied) with the safety cable loop. Adjust
safety cable length by loosening screw and
nut on safety cable vice. [Refer to diagram 6.]
Adjust slack to a hand's length and tighten nut
on vice securely. The loop at the end of the
safety cable should just fit over the threads on
the wood screw. Test safety cable by pulling on
loose end with pliers. If cable slips, then vice and
nut must be set tighter. Extra cable slack can be
left in ceiling area.
electrical wiring
stop pin
hanging ball
canopy
diagram 5
wood ceiling joist
diagram 6
page 6
weatherproof
hanging ball cover
set screw hole
set screw
safety cable loop
wood screw
and washer
safety cable
hanging bracket tab
hanging ball slot
motor housing
Publicité
