Publicité
Les langues disponibles
Les langues disponibles
11. Automated Learning Process./Activating Code.
CAUTION: The wall and/or handheld remote control can be programmed to multiple receivers or fans. If this is
not desired, turn wall switch off to any other programmable receiver or fan.
Restore electrical power and then, if using wall control, set slider switch on wall control to the ON
position. Within 60 seconds of turning on the wall control, press and hold the OFF button on the wall
control for 5 seconds or until light blinks twice.
Turn power off again for at least 5 seconds and then turn power back on. Within 60 seconds of restoring
the power, press and hold the OFF button on the front of the handheld remote control for 5 seconds or
until light blinks twice.
Test the light (if applicable) and fan functions to confirm the learning process is complete--see Section 13
below.
12. Remote/Wall Control Operation.
ON/OFF slider switch - turns wall control ON or OFF
HIGH button - turns fan to HIGH speed
MED button - turns fan to MEDIUM speed
LOW button - turns fan to LOW speed
OFF button - turns fan OFF
L1 button - turns light kit ON/OFF when pressed once;
dims light kit when pressed and held down
L2 button - (not applicable for this fan)
REV button - used to REVERSE blade direction
(fan must be set on low before reversing blade
direction)
13. Testing Your Fan.
It is recommended that you test fan before finalizing
installation. Restore power from circuit box and light
switch (if applicable). Test wall control (optional
installation) by locating ON/OFF slider switch on wall
control, then set to the ON position. Test light (if
applicable) and dimmer function and then test fan
speeds. Next, locate handheld remote control. Test light
(if applicable) ON/OFF function by pressing the L1 button;
test the dimmer function by pressing the L1 button and
holding it down for up to 5 seconds. Test fan speeds with
the different fan speed buttons. If the wall and/or
handheld remote control operate(s) all of the functions
of the fan and light, battery/batteries has (have) been
installed correctly. If the wall and/or handheld remote
control do (does) not operate all of the fan/light
functions, refer to "Troubleshooting" section to solve
any issues before contacting Customer Service.
Fan must be on LOW before setting the fan to reverse
direction. Use "reverse" button (REV) to recirculate air
depending on the season.
NOTE: If the wall control/handheld remote control
interferes with other appliances, turn power off first and
then go back to the instructions in Section 11 above.
(switch not functional on handheld remote)
page 11
-
1 1
-
2 2
handheld
wall control
remote control
motor housing
-
1 1
-
2 2
Publicité
