Publicité
Les langues disponibles
Les langues disponibles
AIR CONDITIONER FEATURES
ELECTRONIC CONTROL OPERATING INSTRUCTIONS
Before you begin, thoroughly familiarize yourself with the control panel as shown below and all its
functions, then follow the symbol for the functions you desire. The unit can be controlled by the unit
controls alone or with the remote.
ADJUSTS
TEMPERATURE
OR TIME
SETS FAN
SPEED
ENERGY
SAVER MODE
CHECK FILTER
RESET
BUTTON
UNIT CONTROL
TO TURN UNIT ON OR OFF:
Press
ON/OFF button to t urn u nit o n o r o ff.
NOTE:Th e u ni t w i l l i ni ti a t e a utomatically the Energy
Saver function under C ool, Dry, Auto (only
Auto-cooling and Auto-fan) modes.
TO CHANGE TEMPERATURE SETTING:
Press
LEFT/RIGTH button to change
/
temperature setting.
NOTE:Press or hold either LEFT
until the desired temperature is seen on the display.
This temperature will be automatically maintained
anywhere between 17 C(62 F) and 30 C(86 F). If
O
you want the display to read the actual room
temperature, see To Operate on Fan Only section.
DISPLAYS
TEMPERATURE
OR TIME OR
ERROR CODES
ADJUSTS
TEMPERATURE
OR TIME
SETS MODE
SLEEP MODE
ACTIVATES
TIMER
TURNS UNIT
ON OR OFF
( ) or RIGTH ( ) button
O
O
O
TO ADJUST FAN SPEEDS:
Press
to select the fan speed in four steps: Auto,
Low, Med or High. Each time the button is pressed,
the fan speed mode is shifted. On Dry mode,the fan
speed is controlled at Low automatically.
SLEEP FEATURE:
Press
Sleep button to initiate the sleep mode. In
this mode the selected temperature will increase by
2 F/1(or 2) C 30 minutes after the mode is selected.
O
O
The temperature will then increase by another 2 F/
1(or 2) C after an additional 30 minutes. T his n ew
O
t emperature w ill be maintained for 6 hours before it
returns to the originally-selected temperature. This
ends the Sleep mode, and the u nit w ill c ontinue t o
o perate as originally programmed. The Sleep mode
program can be cancelled at any time during
operation by pressing the Sleep button again.
CHECK FILTER FEATURE:
Press
Check Filter button to initiate this feature.
This feature is a reminder to clean the air filter for
more efficient operation. The LED (indicator light) will
illuminate after 250 hours of operation. To reset after
cleaning the filter, press the Check Filter button and
the light will go off.
ENERGY SAVER FEATURE:
Press
Energy Saver button to initiate this function.
This function is available on COOL, DRY, AUTO
(only AUTO-COOLING and AUTO-FAN) modes.The
fan will continue to run for 3 minutes after the
compressor shuts off. The fan then cycles on for 2
minutes at 10 minute intervals until the room
temperature is above the set temperature, at which
time the compressor turns back on and cooling
starts.
O
Publicité
