Télécharger Imprimer la page

Midea MW12ECWBA2RCM Mode D'emploi page 18

Publicité

Les langues disponibles

Les langues disponibles

AIR CONDITIONER FEATURES
WARNING
To reduce the risk of fire, electric shock, or injury to
persons, read the IMPORTANT SAFETY
INSTRUCTIONS before operating this appliance.
CAUTION
Please always wait 3 minutes when turning unit off
then on again, and when changing from cool to fan
and back to cool. This prevents compressor from
overheating & possible circuit breaker tripping.
Air Directional Louvers
Lever
Air Direction for 5000BTU/h
Levers
Air Direction for 6000BTU/h,
8000BTU/h, 10000BTU/h, 12000BTU/h
Fresh Air Vent Control
(on
10~12K models
Do not damage or use an unspecified power
cord.
Fig. A
(VENT CLOSED)
The Fresh Air Vent allows the air conditioner to:
1. Recirculate inside air - Vent Closed (See Fig.A)
2. Draw fresh air into the room- Vent Open (see Fig.B)
3. Exchange air from the room and draws fresh air into the room - Vent and Exhaust Open (see Fig.C)
The louvers will allow you to direct the air flow Left or
Right throughout the room as needed.
Move the Levers from side to side until the desired
Left/Right direction is obtained.
The louvers will allow you to direct the air flow Up or Down(on
some models) and Left or Right throughout the room as needed.
Pivot horizontal louvers until the desired Up/Down direction is
obtained.
Move the Lever(s) from side to side until the desired Left/Right
direction is obtained.
):
Fig. B
(VENT OPEN)
To begin operating the air conditioner, follow these steps:
1. Set the thermostat to the highest number (coldest or
cooler setting).
2. Set the selector control to the highest COOL setting.
3. Adjust the louver for comfortable air flow (see Air
Directional Louvers).
4. Once the room has cooled, adjust the thermostat to the
setting you find most comfortable.
5. Make sure that the air flow inside and outside are not
obstructed by anything.
Fig. C
(VENT & EXHAUST
OPEN)

Publicité

loading