Publicité
Les langues disponibles
Les langues disponibles
Unscrew and remove the antenna.
All manuals and user guides at all-guides.com
Reassemble the antenna block by placing the tensioner arm in place and tighten it as shown in
Figure 9.
Figure 9
You can leave out the spring if you like as the ball will not actually be held in place and tension
will not occur with this setup. Reassembly is not necessary; it just serves as a way to keep all of
the original parts without losing them.
The antenna base must be insulated from any electronics. We recommend large shrink tubing or
Blemderm™ tape, as shown in Figure 10.
20
Publicité
