Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
1. Removing the stock RF module
Lay your transmitter face down on a towel or something similar to protect it. Press the two latch
buttons on the top of the transmitter and remove the back of the case. Set the back aside. Locate the
stock RF module and remove it. Save the module in case you need it in the future (returning your
system back to the stock configuration). It will not be re-installed with this upgrade.
See Figure 1.
Figure 1
Cut a hole in the warning label. This is necessary so that the antenna wire can pass through the
housing. See Figure 2 for details.
15
Publicité
