Joerns Oxford Presence Manuel De L'utilisateur page 23

English
*THESE CHECKS SHOULD INCLUDE:
1. SPREADER BAR: Check the spreader bar for freedom of rotation and
swing. Check for wear on the central pivot. Check for firm attachment to the
boom.
2. BOOM: Check the attachment of the boom to the mast. Make sure there is
only minimal side movement of the boom and the boom is free to rotate on
the boom bearing.
3. MAST: Check the operation of the mast-locking device. Make sure the mast
fully engages into the socket. Check the bottom actuator.
4. ACTUATOR: The actuator should require no maintenance other than
checking for correct operation and listening for unusual noise.
5. SMART MONITOR: Check the function of the emergency stop button. Inspect
the hand control socket for correct fitting. Check functioning of the hand control.
Check the redundant controls and confirm they operate as intended.
6. BATTERIES: The batteries are housed in the power pack and should not
require maintenance other than the regular charging as detailed in the
charging instructions. Check that the connections remain clean.
7. LEG ADJUSTMENT: Check the legs operate in both full extensions (inward/
outward).
8. CASTORS: Check all castors for firm attachment to the legs. Check for free
rotation of the castor and the wheels.
9. CLEANING: Clean with ordinary soap and water and/or any hard surfacem
disinfectant. Harsh chemical cleaners or abrasives should be avoided as
these may damage the surface finish of the lift. Avoid wetting any of the
electrical parts.
10. LOAD TEST: The load test should be carried out in accordance with the
manufacturer's test procedures. It is strongly recommended the testing is
carried out by an authorised service dealer.
11. BASE AND WHEELS: Ensure base is even and level (all four wheels are
on the floor).
12. SLINGS: Check for wear and fraying.
13. LUBRICATION: Oil pivot joints, including mast and boom connections, pedal
assembly, spreader bar joint (only if required).
14. HAND SET: Ensure plugged fully into controller.
15. QUICK RELEASE PIN: Ensure the pin is securely fitted before lifting, by
pressing the barbed end.
16. FIXINGS: Check all nuts, bolts, screws and fasteners for excessive wear
and for tightness. Replace as required.
Oxford
®
Presence
ü ü ü
ü ü ü
ü ü ü
ü
ü ü ü
ü
ü ü ü
ü ü ü
ü ü
ü
ü ü ü
ü ü ü
ü
ü ü
ü ü
ü
23