SuperFish Pond Clear 5000 Manuel page 11

Dismantling/Maintenance
Always switch off the power supply when dismantling or carrying out maintenance!
1 Switch the pump off.
2 Drain the water from the device.
3 Carefully unscrew the threaded top from the filter.
4 Unscrew the lid (A) from the UV-C device together with the lamp and replace the special lamp if necessary.
5 Carefully remove the quartz glass (C) with a small coin. Never use force!
6 Clean the quartz glass with a suitable agent. Always use a soft cloth to clean the glass; avoid scratches.
7 Unscrew the elbow and remove the UV-C housing from the drip tray.
8 Remove the drip tray, the collecting tube, the mat, the bio-blocks and the cartridge.
9 Rinse the drip tray, mats and bio-blocks in a bucket of pond water. Do not use tap water to do this, as this would
completely destroy the developed bacterial culture.
10 Re-fit the collecting tube, the bio-blocks, the mat, the cartridge and the drip tray (drawing).
11 Re-mount the UV-C housing in the drip tray and tighten the elbow. When tightening the elbow, pay attention to
the correct position of the sealing ring.
12 Reposition the quartz glass in the UV-C housing. When repositioning the quartz glass in the housing, pay attention
to the correct position of the sealing rings (D).
13 If necessary, spread a little Vaseline on the bottom of the quartz glass (E) to make it easier to re-insert it into the
housing.
14 Re-fit the screw lid (A) onto the housing and hand-tighten.
15 Now test the operation of the UV-C device (see: Installation).
16 Screw the lid onto the filter.
17 Connect the hoses by means of hose clips (not included in the delivery).
18 Switch the pump on and check the system for flow and leakage.
19 Switch the UV-C device on.
Tip:
A 2-way tap can be used for pond pumps with a larger capacity. When selecting the pump, bear in mind that the
pump's output decreases as the water has to be raised to a higher level. So when choosing a pump, always take
account of the difference in height between the water level of the pond and the place of the filter. If in doubt,
consult your pond specialist.
Guarantee conditions
This product is guaranteed against all manufacturing defects for 24 months from the date of purchase. Any material
or manufacturing defects will be corrected during the guarantee period . It is up to the manufacturer to decide
whether to repair or replace any faulty parts. The manufacturer's guarantee covers all substantial defect attributable
to manufacturing or material defects, providing the products has been used correctly and in compliance with the
instructions.
The guarantee becomes null and void in the event of the following:
• unauthorized attempts to repair the appliance • unauthorized technical changes to the appliance • use of non-
original spare parts • manhandling • inappropriate use, e.g. for industrial purposes • installation or operating
faults • faulty maintenance.
The guarantee does not cover:
• parts liable to rapid wear and tear (the lamp is subject to wear and tear and must be replaced after 8,000
lighting hours) • breaking of lamp and quartz glass • discolouration of the product.
The supplier is in no way responsible for damage caused by improper use of the product. The supplier cannot be
held liable for consequential loss caused by the non-operation of the equipment. Guarantee claims can be dealt
with only if the product is returned postage-paid and is accompanied by a valid proof of purchase. Repairs carried
out under the guarantee should be done only by the supplier.
Technical specifications
UV-C (W)
UV-C PL-S Lamp:
UV-C after 5000 hours:
Pond content:
Max pump:
Inlet:
Outlet:
All manuals and user guides at all-guides.com
Pond Clear 5.000
2,3 Watt
9 Watt
85%
±5,000 L
2500l/h
25 mm elbow
32 mm
Pond Clear 7.500
3,4 Watt
11 Watt
85%
±10,000 L
3500 l/h
25 mm elbow
32 mm
11