Laerdal Little Anne Mode D'emploi page 6

Little Anne / AED Little Anne
Maintenance
General manikin cleaning
Routine disinfection of the entire manikin is not required, but periodic cleaning of the head, torso, top skin, and training mat is
recommended. These should be washed with a warm soapy solution, and then rinsed with a clean damp cloth. Proper care will
maintain the appearance and general condition of your Little Anne.
Miscellaneous replacements
To change clicker
To remove
Open the chest cover.
Remove the rib plate.
Set the clicker in the
"off" position (outer position).
Press together the sides
of the clicker and lift it up.
Push it out through the
opening in the torso.
To install
Insert the clicker from outside
(with the pad facing upward).
Press the clicker down until it
snaps into place.
To change clicker activator
The clicker activator is located
underneath the rib plate. It is
fastened by snapping it in place
over the edge and into the two
holes of the rib plate as
illustrated.
To change chest skin
Unhook the chest skin from its
retainers.
Note: For the AED Little Anne model be
aware of wires connecting the chest skin
to the battery box under the rib plate.
Disconnect the two wires from the
battery box (when connecting the new
chest skin wires to the battery box it
does not matter which wire goes to
).
which socket
To change head
To remove
When face, airway and
jaw have been removed
(described in "After class"),
flex the lower edges of
the head outward until the
head can be removed.
To install
Grasp the manikin head
with both hands, with your
fingers on the inside of
the head. Gently pull
outwards and slide the
head onto the neck posts,
one side at a time.
To install the airway, face and jaw, see page 5.
AED Little Anne only
To change battery
AED Little Anne comes with a standard alkaline 6LF22 /
6LR61 9 Volt battery.
- Open the chest skin.
Note: Be aware of wires connecting the chest skin to the
battery box under the rib plate.
- Remove the old battery and install a new 9 Volt alkaline
battery. Be sure to follow the positive (+) and negative (-)
battery icons etched into the inside of the battery holder
when inserting new battery.
Battery low indicators
- Depressing the test button on the battery board will
illuminate the LED's in the chest skin if battery strength is
sufficient for operation. If the LED's do not light when the
button is depressed a new battery is required.
- A "Battery low" voice prompt from the AED Trainer 2 will
be heard immediately after connecting Laerdal Link
training pads if the manikin battery is low.
6