Publicité
Les langues disponibles
Les langues disponibles
5. Repeat this process until up to 8 measurements have been taken.
6. Press the AVERAGE button to display the average of all the
measurements.
7. To display the average air flow, press the MODE button to enter the
area, then MODE again for air flow.
8. To exit this mode and erase all stored readings, press and hold the
AVERAGE button until 2 beeps are heard. To exit without erasing
readings, press the HOLD button.
Data Hold Feature
1. While taking measurements you can freeze the displayed reading by
pressing and holding the HOLD button until a beep is heard.
2. The 'HOLD' indicator will appear on the LCD when the display is in this
mode.
3. Press and hold the HOLD button until a beep is heard to exit this mode.
Changing the Units of Measure
U.S. units of measure are °F, ft/m (feet per minute), and CFM (cubic feet
per minute). Metric units are: °C, m/s (meters per second), and CMS (cubic
meters per second).
1. Turn the meter on by pressing and holding both the ON/OFF and the
AVERAGE buttons simultaneously. Release the ON/OFF button first
then release the AVERAGE button. The units of measure will appear
on the LCD.
2. Press the HOLD button to select Metric and the AVERAGE button to
select U.S.
3. Press the MIN MAX button and an "S" will appear on the LCD.
4. Press the HOLD button to advance to the next selection.
5. The baud rate for PC Interface models will appear (1200 or 2400). Select
the baud rate, if necessary, by pressing the HOLD (1200) or AVERAGE
(2400) button.
6. To return to normal operation, press MIN MAX again (the "S" will
reappear) then press and hold the HOLD button until the beep is heard.
All manuals and user guides at all-guides.com
6
Publicité
