Télécharger Imprimer la page

Amprobe TMA10A Mode D'emploi page 10

Masquer les pouces Voir aussi pour TMA10A:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

MAKING MEASUREMENTS
Air Velocity Measurements
Air velocity and temperature measurements can be displayed on this
meter in the following units of measure: ft/m (feet per minute) or m/s
(meters per second) for air velocity and °F or °C for temperature.
1. Connect the sensor to the sensor input jack on top of the meter.
2. Turn on the meter using the ON/OFF button.
3. The 'Vel' indicator should appear on the upper left on the LCD. If
not, press and hold the MODE button until a beep is heard. Repeat
this procedure until 'Vel' appears on the display.
4. Place the sensor in the air current to be measured.
5. View the air velocity and temperature readings on the LCD Display.
The upper display shows the air velocity reading. The lower display
shows the temperature.
Air Flow Measurements
In order to take air flow measurements, the area of the duct under test (in
ft2 or m2) must first be determined (check with the duct manufacturer if
necessary). Once the area is known, enter the value as follows:
1. Turn on the meter with the ON/OFF button.
2. Press and hold the MODE button until a beep is heard. "AREA"
appears on the display and one digit will be blinking indicating that
value can be changed.
3. Press the HOLD button to adjust the digit to the value needed.
4. Press the AVERAGE button to select the next digit for editing.
5. When the area is correctly entered, press the MIN MAX button
once. A beep will sound and the digits will stop blinking.
6. Press the HOLD button once to store the area value.
7. The meter is now ready to measure air flow. Place the sensor in the air
current and view the air flow and temperature readings on the LCD.
All manuals and user guides at all-guides.com
4

Publicité

loading