Lindy 32924 Manuel page 5

English Manual
OPERATION
Your monitor will only display one PC signal at any one time. All keyboard and mouse
commands are sent to this PC only.
After initial power up, port 1 is active by default. When a PC is connected to this port and it is
not switched on or is in sleep mode, the monitor will not show any signal. Please note that this
is not the sign of a faulty CPU Switch!
The Red Push Button:
Pressing the button switches the PC ports cyclically:
Version 1:2 (No.):
LED Indicators
LED Status Meaning
ON This PC port is selected and the PC is powered ON
OFF This PC port is not selected
Flashing This PC port is selected but the PC is powered OFF
Direct Port Selection / Keyboard Hot Key Commands:
You can also conveniently command the CPU Switch LITE to switch the CPU port using simple
key sequences. To send commands to the KVM switch the SCROLL LOCK key must be
pressed twice within 2 seconds. You will hear a beep for confirmation.
Within 2 seconds
+
Scroll Scroll
Lock Lock
+
Select PC port :
+
Scroll Scroll
Lock Lock
Beeper Function:
Scroll Scroll
+ +
Lock Lock
Auto Scan Mode:
Scroll Scroll
+
Lock Lock
1 2
↑
+ = Previous Channel
or
↓
+ = Next Channel
Port No.
+
1...2/4
B
= Beeper
S
+ = Auto Scan (The scan interval is 8 seconds)
Version 1:4 (No. ):
= To select PC1 ~ PC2 or ~ PC4 directly
To get out of Auto Scan Mode,
Press any key or SPACE bar.
2
1 2
4 3