Panasonic KX-HNC600C Guide D'installation page 19

Installing the camera
1
Attach the safety wire to the camera.
R Place the ring of the safety wire (A)
over the screw hole.
R Place a washer (B) on top of the ring
of the safety wire.
R Tighten the screw (C) for the safety
wire on top of the washer.
2
3
2
Attach the camera mounting stand to an
outdoor wall.
R Secure the stand to the wall by
tightening 4 screws (A).
R 37 mm (1 15/32 inches)
1
1
1
For assistance, visit www.panasonic.ca/english/support
HNC600C_(en_en)_0113_ver.201.pdf
1
1
1
19
Note:
R Use the following template below when
determining the location of the screw
holes.
37 mm
(1 15/32 inches)
37 mm
(1 15/32 inches)
Setup
19
2017/01/13 11:54:13