Panasonic KX-HNC600C Guide D'installation page 16

Setup
Registering the camera
This procedure is not required for devices
that were included as part of a bundle.
Before you can use the camera, it must be
registered to the hub.
If the camera is not registered to a hub, the
camera's LED indicator blinks slowly in amber.
You can register each device by using the
registration buttons or the [Home Network]
app.
Note:
R Before registering the camera, make sure
the AC adaptors of the hub and camera are
connected and each device is powered.
Using registration buttons
1
Hub:
Press and hold M
LED indicator blinks slowly in green.
2
Camera:
Using an object with a thin tip, press and
hold M N until the LED indicator blinks
slowly in green (page 15).
R When registration is complete, the hub
sounds one long beep.
Note:
R To cancel without registering the camera,
press M N on the hub and on the camera
again.
R If registration fails, the hub sounds several
short beeps.
For assistance, visit www.panasonic.ca/english/support
16
HNC600C_(en_en)_0113_ver.201.pdf
Using the app
When you register the camera by using the
[Home Network] app, you can assign a name
to your devices and group them by location.
For more information, refer to the User's
Guide (page 26).
Confirming the installation
area
Before deciding where to install the camera,
carefully read the chapter "Installation
Location", beginning on page 8, to confirm the
installation location and direction.
CAMERAN until the
16 2017/01/13 11:54:13