Trix V 300 Serie Mode D'emploi page 8

Function
• Built-in electronic circuit for operation with a conventional
DC power pack (max. ±12 volts), Trix Systems, Trix Selectrix
or NMRA DCC digital systems.
• Automatic system recognition between digital and analog
operation.
• No automatic system recognition between Selectrix (SX) and
DCC.
• The full range of functions is only available under Trix Sys-
tems and under DCC.
• Headlights for the locomotive change over with the direction
of travel. They can be turned on and off in digital operation.
Notes on digital operation:
• The first time the locomotive is used in a digital system
(Selectrix or DCC), the decoder must be set for this digital
system. To do this, the decoder must be programmed once in
this digital system (Example: changing an address).
• The operating instructions for your central unit will give you
exact procedures for setting the different parameters.
• The values set at the factory were selected to guarantee the
best possible running characteristics.
• This locomotive comes from the factory programmed for the
digital address "01" (Selectrix) / "03" (DCC) Number of speed
levels that have been set: 28 (DCC) and 31 (Selectrix).
• Correct programming with the 66920 Mobile Station is possib-
le starting with version number 034.
• Information about DCC Operation:
The setting done at the factory does not permit operation with
opposite polarity DC power in the braking block. If you want
8
All manuals and user guides at all-guides.com
Safety Information
• This locomotive is only to be used with the operating system
• This locomotive must not be supplied with power simultane-
• Please make note of the safety information in the instructions
• The feeder track must be equipped to prevent interference
WARNING! This product contains magnets. Swallowing more
than one magnet may cause death in certain circumstances. If
necessary, see a doctor immediately.
this characteristic, you must do without conventional DC power
operation (CV29 / Bit 2 = 0).
it is designed for.
ously by more than one power source.
for your operating system.
with radio and television reception, when the locomotive is
to be run in conventional operation. The 611 655 interference
suppression set is to be used for this purpose. The interfe-
rence suppression set is not suitable for digital operation.
The built-in speaker can possibly activate reed switches
built into the track.