Pommier 2909400 Notice Originale page 8

GEOMETRIC CONDITIONS
• The rear underrun bar must only be fitted on vehicles that meet one of the following criteria:
– M1, N1, N2, N3 or O1, O2, O3, O4* and R3, R4** category vehicles with a height A of above 550 mm.
– Max. total weight of the vehicle: All GCWR
– The minimum rigidity of the side rails must be: I/V ≥ 160 cm
• The position of the under-run bar must ensure compliance with the dimension of 600 mm at the center of the under-
run bar (measured when empty) and the dimension "P" (see figures 1a and 1b).
*See Directive 2007/46/EEC for the definition of vehicle categories.
** See Regulation 167-2013-acceptance of agricultural vehicle.
MOUNTING UNDER CHASSIS
Possible side rail types
Sub-frame
Side rail
Centre of the bar
P=255 max. (steel bar 2909400)
P=351 max. (aluminium bar 2909401)
P=360 max. (aluminium bar light bracket 2909409)
P=336 max, (aluminium bar height 150mm 2909427)
Ground
L = Possible frame width from min. 860 to max. 1360
Max.
Fig.2a
Tube trimming possible in accordance with the max. 100 with respect to the outermost points of wheels, not taking account of the bulging
of tyres on contact with the ground.
Rear of the vehicle
Fig.1a
Sub-frame
Ground
3
.
Possible side rail types
Sub-frame
P=321 max. (steel bar 2909402, 2909421)
P=296 max. (aluminium bar 2909403)
P=304 max. (aluminium bar light bracket 2909420)
P=314 max, (aluminium bar height 150mm 2909426)
L = Possible frame width from min. 750 to max. 900 for all GCWR
L = Possible frame width of 700 with 2 shims of 25 between the plate and
L = Possible frame width from min. 901 to max. 1690 for 6.3 T
Max.
Max.
L = Possible frame width from min. 980 to 1100 max. for all GCWR
Max.
SIDE MOUNTING
Rear of the vehicle
Side rail
Centre of the bar
Ground
Fig.1b
side rail for all GCWR
Sub-frame
Ground
Fig.2b
Sub-frame
Ground
Max.
Max.
8/36