Pommier 2909400 Notice Originale page 12

LIGHTING AND SIGNALLING DEVICES AND ACCESSORIES
These devices must be installed in accordance with Directive 2007/46/EEC modified by Directive 97/28 and Geneva
regulation No. 48.
This is a certified product and only the adaptations suggested in this manual are permitted. To mount certain items, we
allow:
• The fitting of reflectors on the ends of the tube using the method of your choice. The reflectors and their attachment
method must not cover a radius of < 2.5mm.
• Welding of the plates, arms and the tube for installing cable grommets, brackets for sensors and other accessories.
The maximum length of weld beads is 50 mm, spaced a min. of 150mm apart.
• The drilling of holes with a max. Ø10 in the tube. At min. 5 mm from the ends, spaced a min. of 150 mm apart along
the length and a min. of 50 mm over the height.
• The drilling of holes with a max. Ø10 in the arms. At min. 30mm from all cuts and ends, spaced 100 mm apart.
The trimming of the ends of the tube in accordance with the dimensions in figures 2a and 2b.
PAINTING
• Ensure that the EEC marking remains legible after painting.
MAINTENANCE
After use on the road, check the following:
• Check the tightening torque of screws after 1000 and 2000 km of road use, re-tighten to the specified torque, if
necessary.
• As part of the truck's routine servicing, periodically check the tightening torque of mounting screws.
END OF PRODUCT LIFE
• All products taken out of use must be reclaimed or recycled via the appropriate collection and disposal channels, if
possible.
ADDITIONAL PRODUCT: coupling tow bar kit, 3.5 t, see "Universal tow bar" catalogue
Product compatible with Product refs. 2909402, 2909403, 2909421
Fixed underrun bar
Type BAP
Mounting kit 29.44576
12/36