Pommier 2909400 Notice Originale page 11

D-Aluminium bar (bolted on)
Thread the 4 bolts (1) (see detail AA) with 4 washers (2) (see detail AA) into the bar's guides, position them as in the
following figure and maintain the symmetry for the second arm (see detail AA), check the max. dimension of 100 mm
(see Fig. 2a and 2b), put the 4 washers (3) (see detail AA) and the 4 nuts (4) (see detail AA) in place and tighten to a torque
of 80 Nm ± 10%.
Fig. 6b
Fig. 6a
Fig. 6b
Fig. 6a
11/36