Publicité
Les langues disponibles
Les langues disponibles
Maintenance
POTENTIAL HAZARD
When extension cord is connected to mower
and plugged into a normal household
outlet, the mower is operational. Someone
could accidentally start the mower.
WHAT CAN HAPPEN
Accidental starting of mower could
seriously injure you or other bystanders.
HOW TO AVOID THE HAZARD
Always remove extension cord from mower
receptacle when leaving mower unattended,
even for a short period of time.
Cleaning
Before cleaning mower, stop motor, wait for all
moving parts to stop, and disconnect extension cord
from mower.
IMPORTANT: Do not clean mower with a
garden hose. Moisture can be trapped in
mower and may cause corrosion of internal
parts.
After Every Use
Clean the underside of the mower housing. Be
particularly careful to keep the front cavity clear
of all debris (Fig. 17). Remove dirt and grass
clippings with a hardwood scraper. Avoid burrs
and sharp edges.
Brush all debris off top of mower housing.
Inspect plug receptacle for signs of melting or
heating. Old, worn out extension cord plugs that
fit loosely in the plug receptacle can cause
overheating from poor contact. Replace any
damaged extension cords immediately.
Once A Year
Remove top shroud (Fig. 18) and clean out any
debris underneath it with compressed air, a
vacuum cleaner or a brush.
Check for any discolored or charred wires or
switch contacts. If any are damaged, see your
Authorized Toro Service Dealer for repairs.
Inspect the drive belt and replace if worn or
cracked.
Blade
Always mow with a sharp blade. A sharp blade cuts
cleanly and without tearing or shredding the grass
blades like a dull blade.
POTENTIAL HAZARD
Motor could be started by someone
accidentally.
WHAT CAN HAPPEN
Accidental starting of motor could cause
serious injury to operator or bystanders.
HOW TO AVOID THE HAZARD
Do not attempt to inspect, remove or
replace blade without first disconnecting
extension cord from the mower.
1.
Stop motor and wait for all moving parts to stop.
Disconnect extension cord from mower.
2.
Tip mower on its side (Fig. 17).
3.
EXAMINING BLADE – Carefully examine
blade for sharpness and wear, especially where
flat and curved parts meet (Fig. 19A). Since sand
and abrasive material can wear away the metal
that connects the flat and curved parts of the
blade, check blade before using the mower. If a
slot or wear is noticed (Fig. 19B & 19C), replace
blade. Refer to step 4.
EN–10
Publicité
