EINHELL RT-SB 250 U Mode D'emploi D'origine page 20

Anleitung_RT_SB_250_U_SPK7:_
GB
4. Important notes
Safety information
IMPORTANT! Whenever you use electric tools it is
imperative to take basic safety precautions in order
to reduce the risk of fire, electric shock and personal
injury.
The corresponding safety information can be found
in the enclosed booklet.
CAUTION!
Read all safety regulations and instructions.
Any errors made in following the safety regulations
and instructions may result in an electric shock, fire
and/or serious injury.
Keep all safety regulations and instructions in a
safe place for future use.
5. Technical data
Voltage:
Power:
Ideal speed no:
Blade length:
Max. blade width:
Blade speed:
Max. cutting height:
Throat:
Table size:
Tilting range of table:
Workpiece size:
Weight:
Noise emission values
Sound and vibration values were measured in
accordance with EN 61029.
L sound pressure level
pA
K uncertainty
pA
L sound power level
WA
K uncertainty
WA
Wear ear-muffs.
The impact of noise can cause damage to hearing.
20
10.02.2012 9:57 Uhr
Keep the noise emissions and vibrations to a
minimum.
Only use appliances which are in perfect working
order.
Service and clean the appliance regularly.
Adapt your working style to suit the appliance.
Do not overload the appliance.
Have the appliance serviced whenever
necessary.
Switch the appliance off when it is not in use.
6. Before putting the machine into
operation
Make sure the machine stands securely, i.e. bolt
it to a workbench or solid base. There are two
holes for this purpose in the machine foot.
The saw table must be mounted correctly.
All covers and safety devices have to be properly
fitted before the machine is switched on.
It must be possible for the blade to run freely.
When working with wood that has been
220-240V ~ 50 Hz
processed before, watch out for foreign bodies
420 W such as nails or screws etc.
Before you actuate the On/Off switch, make sure
1400 min -1
that the saw blade is correctly fitted and that the
1790 mm
machineʼs moving parts run smoothly.
Before you connect the machine to the power
9,5 mm
supply, make sure the data on the rating plate is
660/960 m/min
the same as that for your mains.
120 mm / 90°
70 mm / 45°
7. Assembly
245 mm
290 x 290 mm
CAUTION!
0° to 45°
Pull out the power plug before carrying out any
maintenance, resetting or assembly work on the
350 x 350 mm
bandsaw!
32,8 kg
7.1 Assembling the base frame and bolting the
saw to the base frame (Fig. 7-23)
Insert the feet (A) from the bottom into the
intermediate struts (C) as shown in Figure 7.
Ensure that the rubber stoppers on the feet (A)
are aligned so that the support surfaces are level.
Screw the feet (A) to the intermediate struts (C)
using the screws (N), washers (H) and nuts (G)
77,4 dB(A)
as shown in Figures 8 - 9.
3 dB
Guide the side parts (B) from the top over the
90,4 dB(A)
intermediate struts (C) (Figure 10).
3 dB
At each connection point screw the side parts (B)
to the intermediate struts (C) using three screws
(L), washers (K) and nuts (I) (Figures 11-12).
Insert the two bottom cross struts (E) into the
Seite 20