Special Product Features; Side Handle Installation; Switching On And Off; Selection Of Direction Of Rotation - Metabo BE 622 S- R+L Mode D'emploi

ENGLISH
ENG
Caution must be exercised when driving screws
into hard materials (driving screws with metric or
imperial threads into steel)! The screw head may
break or high reverse torques may build up.
High forces are released if the tool jams or catches.
Always hold the tool firmly, ensure you have good
footing and concentrate when working.
Secure small workpieces. Clamp in a vice for
example.
Dust from material such as paint containing lead,
some wood species, minerals and metal may be
harmful. Contact with or inhalation of the dust may
cause allergic reactions and/or respiratory
diseases to the operator or bystanders.
Certain kinds of dust are classified as carcinogenic
such as oak and beech dust especially in conjunc-
tion with additives for wood conditioning (chro-
mate, wood preservative). Material containing
asbestos must only be treated by specialists.
- Where the use of a dust extraction device is
possible it shall be used.
- The work place must be well ventilated.
- The use of a dust mask of filter class P2 is
recommended.
Follow national requirements for the materials you
want to work with.
5 Overview
See page 3 (please unfold).
1 Geared chuck
2 Side handle
3 Rotation selector switch
4 Trigger
5 Locking button (continuous activation)

6 Special Product Features

Metabo S-automatic safety clutch:
If the insertion tool jams or hooks, the power flow to
the engine will be restricted. Because of the high
power which then arises, always hold the machine
with both hands on the handles, stand safely, and
concentrate on your work.
Turn-off carbon brushes: If the brushes are
completely worn, the machine switches off automa-
tically.
7 Commissioning
Before plugging in, check to see that the
rated mains voltage and mains frequency,
as stated on the rating label, match with your
power supply.
10
To guarantee secure purchase of the
chuck: After initial drilling (clockwise),
use a screwdriver to firmly tighten the safety screw
inside the drill chuck. Caution left-handed thread!
(see Section 8.4)
7.1

Side handle installation

For safety reasons, always use the side
handle supplied.
Open the clamping ring by turning the side handle
(2) counter-clockwise. Place the side handle onto
the machine's collar. Tighten the side handle in the
required angle depending on the task at hand.
8 Use
8.1

Switching On and Off

To start the machine, press the trigger switch (4).
The speed can be changed at the trigger switch by
pressing.
For continuous operation the trigger switch can be
locked using the lock button (5). To stop the
machine, press the trigger switch again.
In continuous operation, the machine
continues running if it is forced out of your
hands. Therefore, always hold the machine
with both hands using the handles provided,
stand in a safe position and concentrate.
8.2

Selection of direction of rotation

Do not activate the rotation selector
switch (3) unless the motor has
completely stopped.
Select direction of rotation:
R = Clockwise
L = Counter-clockwise
The drill chuck must be firmly screwed
onto the spindle and the safety screw
inside the drill chuck must be firmly tightened
with a screwdriver. (Caution, left-handed
thread!) If rotated counterclockwise (e.g. when
screwing) it could otherwise become loose.